CCNA 2 R&S Routing and Switching Essentials Chapter 7 Exam

CCNA 2 R&S Routing and Switching Essentials Chapter 7 Exam

CCNA 2 R&S Routing and Switching Essentials Chapter 7 Exam

  • Nicoli

    There have been some question changes. I only have a few of them. I’m guessing about 4 to 7 of the questions are different. here are some of the new ones:

    After a network topology change occurs, which distance vector routing protocol can send an update message directly to a single neighboring router without unnecessarily notifying other routers?

    RIPv1

    EIGRP

    IS-IS

    RIPv2

    OSPF

    What is a disadvantage of using dynamic routing protocols?

    They are only suitable for simple topologies.

    They require administrator intervention when the pathway of traffic changes.

    Their configuration complexity increases as the size of the network grows.

    They send messages about network status insecurely across networks by default.

    Refer to the exhibit. A network administrator has issued the exhibited commands in an attempt to activate RIPng on interface gig0/0. What is causing the console message that is shown after RIP is enabled?

    Interface gig0/0 does not have a valid IPv6 address.

    IPv6 unicast routing has not been enabled on this router.

    Interface gig0/0 is shutdown.

    IPv6 is not supported on this IOS.